Automatic Controller for DIY Hoist Elevator by OffGridOnline - Version 7.0

Description

IMPORTANT NOTES:
This item is the Controller Unit Only.
Updates to this controller design are ongoing so you may see some variation from the pictures above. You will always receive the newest model available.
Buttons
and
Limit Switches
are sold separately from this item.
This newest design makes connections much easier than previous designs.
With clearly marked screw terminals and integrated high voltage connections, wiring this unit should be a breeze.
This kit provides all of the electronics you will need to automatically control an elevator/platform moved by a hoist/motor.
It does not include the hoist but instructions will be provided to connect to your hoist/motor.
This unit will allow motion between two or  three locations.
For each location that you wish to have buttons
, you will need to have the following:
* one momentary button for each floor in your system (Two floor = 2 buttons for each button panel; Three floor = 3 buttons for each button panel).
*One emergency stop button (Normally Closed in the operating position).
You can use your own buttons or you can purchase a
Button Add-On Pack
by OffGridOnline (Sold Separately)  on our site as well.
You will need to have limit switches for this unit as follows:
1 qty- Normally Open Proximity limit switch
for each floor you need to stop at
(Minimum 2 for top and bottom floor)
2 qty- Normally Closed Proximity limit switches for the backup limit switches (Safety measure in case the floor switches fail)
You can use your own buttons or you can purchase a
Limit Switch Add-On Pack
by OffGridOnline. (Sold Separately)
This item includes the following:
1 qty. Control Unit with built-in LCD Display
1 qty. Power Adapter